specred package
Guest wrote on May 24, 2006
I am trying to do a multi-fiber spectroscopic reduction using the specred package. I am using a 293 fiber system and there is moderate curvature of the spectral lines. I am encountering a problem when re-identifying spectral lines from my first arc spectrum...when I run dofibers the identify task starts with trace #146 and proceeds 145,144...2,1,147,148,149...290. The problem is the jump from 1 to 147 because there is a large shift at that point. I have tried setting the identify.section="first line" so it starts with the first trace and proceeds along the lines such that the change is continuosly small, however it always starts with #146 and also appears to sum 10 fibers. I have enclosed a .jpg of the comp.ms.fits image for reference. I would greatly appreciate any insight for resolving my dilemma. Thank You,
Andy Monson
amonson@uwyo.edu
University of Wyoming
Post generated using Mail2Forum (http://www.mail2forum.com)
Andy Monson
amonson@uwyo.edu
University of Wyoming
Post generated using Mail2Forum (http://www.mail2forum.com)
Francisco Valdes wrote on May 24, 2006
Hello Andy,
First, the order in which you see the steps being done does not specifically mean that it is carrying over from last fiber. In particular the jump from 1 to 147 almost certainly does not mean that it is using the positions from 1 to start on 147. However, there are other parameters that may be affecting things. If you would like to send me a parameter listing (e.g. lpar reidentify specred) I might see something in what you are doing. This would be a first step. If it is still not obvious I would need to try this myself on some data you supply.
Frank Valdes
First, the order in which you see the steps being done does not specifically mean that it is carrying over from last fiber. In particular the jump from 1 to 147 almost certainly does not mean that it is using the positions from 1 to start on 147. However, there are other parameters that may be affecting things. If you would like to send me a parameter listing (e.g. lpar reidentify specred) I might see something in what you are doing. This would be a first step. If it is still not obvious I would need to try this myself on some data you supply.
Frank Valdes
Last post on May 24, 2006